# How Much Does A 60 Lb Bag Of Concrete Cover?

## How much does a 60 lb bag of sand cover?

1 bag yields approximately 0.6 cu.

ft.

Will fill an area approximately 7 sq.

ft..

## Can you pour concrete directly on dirt?

No, Because concrete slabs “float” on the soil, soft ground or voids underneath may cause unsupported areas to crack under heavy weight like vehicles. Pack about 4 in. of sand or gravel over clay and other poorly draining soils to provide even support.

## How many square feet does 60 lbs of concrete cover?

One 50-pound bag of Quikrete Fast Setting Concrete Mix yields about . 375 cubic feet. For example, if you need to cover 33.333 cubic feet, using 60-pound bags of concrete, divide 33.333 cubic feet by .

## How much area will a 50 lb bag of sand cover?

For 2 inches of sand: 128 divided by 1/6 (2/12)=21.3 cubic feet or about ¾ cubic yard. A 50 pound bag of sand is about 3 cubic feet…so it looks like 7-8 bags should work for 2 inch depth.

## How many 80 pound bags of concrete does it take to make a yard?

An 80# bag of pre-mixed cement, sand and gravel (CONCRETE) is 0.6 cubic foot per the bag. There are 27 cubic feet in a cubic yard. So 27 / 0.6 = 45 80# bags.

## Is 2 feet deep enough for fence posts?

The minimum depth that you should dig your fence post holes for panel sections is 2 feet. A general formula is to dig the holes one-third to one-half of the post’s aboveground height. The deeper you dig the holes, the more stability your fence has, but you must also purchase longer posts.

## How many 60 pound bags of cement does it take to make a yard?

60 pound bag yields .017 cubic yards. 80 pound bag yields .022 cubic yards.

## How much does a 60 lb bag of concrete cost?

Compare Similar Products60 lb. Gray Concrete Mix50 lb. Fast Set Concrete Mix5000 Plus 80 lb. Concrete Mix\$3.15\$5.48\$6.30(1350)(586)(204)Product Weight (lb.) 60 lbProduct Weight (lb.) 50 lbProduct Weight (lb.) 80 lbCompression Strength (psi) 4000Compression Strength (psi) 4000Compression Strength (psi) 50006 more rows

## Do fence posts need concrete?

Concrete is the most secure material for setting fence posts, especially if you have sandy soil. Gravel may be okay with dense, clay-heavy soil, but in looser soil, concrete is the only thing that will truly keep your fence posts stuck in place.

## How much is a 5 gallon bucket of concrete?

A five gallon bucket can hold . 45 cubic feet of concrete when mixed with water. In other words, one 60 pound bag of pre-mix or an equivalent Portland Cement/rock and sand mix.

## What’s the difference between play sand and regular sand?

Over the years we have been asked the question “What is the difference between play sand and builders sand?” The simple answer to this is that play sand is a less coarse, much finer version of builders sand that has been through certain processes to make sure it is safe for children to play with.

## How do you estimate concrete?

Multiply the width times the length times the height (W x L x H). You can also use our volume calculator to find cubic yardage of a space. Convert the volume to cubic yards from cubic feet. To do so, divide the cubic footage by 27 to get the yards of concrete needed.

## How thick should a concrete driveway be?

four inchesAs for thickness, non-reinforced pavement four inches thick is standard for passenger car driveways. For heavier vehicles, a thickness of five inches is recommended. To eliminate standing water, the driveway should be sloped towards the street a minimum of one percent, or 1/8 inch per foot, for proper drainage.

## How many bags of concrete do I need for a 4×4 post?

Mix two 50lb bags of concrete with water in a mixing tub or 5-gallon bucket. Add concrete into the hole and around the 4” x 4”.

## How many bags of cement do I need for 1 yard?

5 Bags# It takes approximately 5 Bags of Portland cement, 8 cubic ft of sand, and 20 cubic ft of gravel to make approximately 1 cubic yard (27 cubic feet) of concrete.

## How many cubic feet are in a 60 pound bag of concrete?

0.45 cubic feetA 60 lb. bag provides 0.45 cubic feet of cured concrete.

## Can I mix cement in a bucket?

If you need to mix concrete by hand, there are two options: … It has all the ingredients dry mixed together for making concrete, i.e. the cement, sand and stone. All you have to do is put it into a bucket, wheelbarrow or on a piece of plastic on the ground, add water and spend a few minutes mixing it.

## How much sand do I need for a 10×10 patio?

The recommended depth of sand for laying pavers is 1 inch. As one inch is 1/12 of a foot, divide the surface area, in square feet, by 12 to find the cubic feet of sand required. For example, a 60-square-foot patio requires 5 cubic feet of sand because 60/12 = 5.

## Is fast setting concrete weaker?

Fast-setting concrete isn’t just simple and fast, it’s also durable and strong, reaching 4000 psi — or pounds of force per square inch —after a month. That’s stronger than the concrete used for foundations on most homes.

## How big of a hole do I need for a 4×4 post?

A general rule of thumb is to dig the diameter of the hole at least 3-4 times the diameter of the post. For example, if setting 4 x 4 wood posts, dig holes 9-12″ in diameter. Posts should be centered in the hole and the posts should always have concrete under them.

## How much water do I add to a 60 lb bag of Sakrete?

4. Clean all reinforcing steel to bare white metal and coat with a rust preventative if not covering within 8 hours. Bag Size Yield Water 40 lb (18.1 kg) 0.30 ft3 (. 008 m3) 1.75 qt (1.7 L) 60 lb (27.2 kg) 0.45 ft3 (.